Page History

...

• Setup an SQL database connection
• Configure MQTT Engine
  • Add/update the Server configuration to point to the MQTT server
• Configure MQTT Recorder and configure it to use SQL database connection (previously set up in the Ignition Gateway)

At the Edge Gateway

• Configure MQTT Transmission
  • Add/update the Transmitter configuration and/or the Tag folders so that an Edge Node is reporting with a Group ID, Edge Node ID, and Device ID (for example: G1, E1, D1)
  • Add/update the Server configuration to point to the MQTT server
  • From Ignition Designer, use the MQTT Transmission 'Refresh' Mechanism to make sure it is connected and reporting.
• Configure EFM Emerson ROC module
  

  • The Alarm, Event, and/or History poll rates in the Emerson ROC driver device configuration must be greater than zero depending on which data you wish to collect.

    Warning
    Must have a Sparkplug Group ID, Edge Node ID, and Device ID specified in the device configuration that matches the Edge Node/Device that MQTT Transmission is reporting on

    
    

When all of these conditions are met, alarm, event, and/or history data will be collected, published, and stored via MQTT Recorder in the configured database.