Page History

The Opto 22 groov EPIC and SNAP PAC Driver module is an Ignition driver for accessing Tags directly from Opto 22 groov EPIC and SNAP PAC™ controllers and OptoEMU™ sensors.

Supported Opto 22 products and firmware

• All groov EPIC and SNAP PAC controllers and SoftPAC™ software-based controllers with PAC firmware R9.2c or higherAll OptoEMU energy management sensors with OptoEMU firmware R3.0b or higher

For the versions of Ignition recommended for this driver, see Cirrus Link’s Module Installation.

To download the driver module:

1. Go to Inductive Automation’s Ignition Downloads webpageto Inductive Automation's Strategic Partner Modules download page.
2. Select the version of Ignition you are using so the proper compatible modules appear.
3. Scroll down to Third Party Modules. Under , under Cirrus Link Solution MQTT Modules for Ignition, select Opto-22-groov-EPIC-and-SNAP-PAC-Driver-signed.modl. 

More information including installation instructions can be found in the links below.

• Cirrus Link Module Installation
  • Step by step instructions to install modules into Ignition
• Opto 22 groov EPIC and SNAP PAC Module Configuration
  • Configuration guide for the AWS Injector Opto 22 module
• Opto 22 groov EPIC and SNAP PAC Module Tutorials/Howtos
  
  • Tutorials and howtos covering installation, configurations, and usage of AWS Injector
• Opto 22 groov EPIC and SNAP PAC Module Videos
  • Installing the Driver moduleCreating and populating the stPublicListOfStrategyTags table
  • Configuring the Driver module
  • Scanning Specific Tags