Page History

...

Shown below is an example for 64-bit Linux.  After entering the target image into the name field, click the 'Pull the Image' button to download it.  You must have internet connectivity for this to succeed.  Once the download is complete, you should see something similar to the following.

Image RemovedImage Added

Step 3: Create the Volumes

...

This is all shown below in the 64-bit Linux example.

Image RemovedImage Added

In addition set the following advanced properties via the bottom tabs.

• Map the Volumes as shown below.

Image RemovedImage Added

• Set the Restart policy as shown below.

...

After deploying you should see the new container now running as shown below.

Image RemovedImage Added

Step 5: Connect to the

...

Ignition Edge Web UI and start using Ignition Edge MQTT

At this point you are ready to configure and use Ignition Edge MQTT.  The Ignition web UI is available on the docker port 8088.  If you mapped 8088 → 8088, you can access the Ignition Web UI by browsing to http://[docker_host_ip]:8088.

...

• MT: Configuration
• Getting Started: Two Ignition Architecture

Notes

If using a Hilscher Gateway with Docker support, make sure you set 'Docker Autostart' to 'enabled' as shown below.

Image Added