Page History

...

After doing so, you should see something similar to what is shown below. Note the last line is 'MQTT Client connected to ...'. That denotes we have successfully configured IBAS and properly provisioned AWS IoT Core.

Anchor

...

EdgeSetupWithIgnitionAndMqttTransmission EdgeSetupWithIgnitionAndMqttTransmission

...

Edge Setup with Ignition and MQTT Transmission

At this point IoT Bridge is configured and ready to receive data. To get data flowing into IBAS we'll set up Inductive Automation's Ignition platform along with the MQTT Transmission module from Cirrus Link. Begin by downloading Ignition here.

...

With Ignition and MQTT Transmission installed, we can configure the MQTT Transmission module to connect to AWS IoT Core using the same certificates that we provisioned earlier. Begin by clicking 'Get Desginer' in the upper right hand corner of the Ignition Gateway Web UI as shown below.

EdgeSetupWithIgnitionAndMqttTransmission

Now launch the Ignition Designer using the Designer Launcher as shown below.

...