Page History

...

After deploying you should see the new container now running as shown below.

Step 5: Connect to the

...

Ignition Edge Web UI and start using Ignition Edge MQTT

At this point you are ready to configure and use Ignition Edge MQTT.  The Ignition web UI is available on the docker port 8088.  If you mapped 8088 → 8088, you can access the Ignition Web UI by browsing to http://[docker_host_ip]:8088.

...

• MT: Configuration
• Getting Started: Two Ignition Architecture

Notes

If using a Hilscher Gateway with Docker support, make sure you set 'Docker Autostart' to 'enabled' as shown below.

Image Added