Cirrus Link Website
Contact Us (Sales/Support)
Forum
Cirrus Link Modules Docs for Ignition 8.1.x
Cirrus Link Modules Docs for Ignition 7.9.x
Ignition User Manual
Knowledge Base Articles
Inductive University
Forum
...
Navigate to the Azure Injector Module configuration section from the left side bar in the Ignition Gateway. From the Azure IoT Hubs tab, click on the "Create new Azure Add IoT Hub Setting..." link to bring up the following configuration form:
Set the following parameters:
...
Click on "Create New Azure IoT Hub Setting" to finish creating the new configuration setting.
Now the Azure Injector module is connected to the IoT Hub, we have to determine if there are are changes needed to the Tag Agent tab to be able to push data.
If you already have Ignition tags defined, for example from the Ignition OPC UA Server, then depending on the depth of your tag tree you may need to configure the Sparkplug Settings.
| Tip |
|---|
| Review the Cloud Injector Tag Agents and Tag Trees document which describes how Cloud Injector Agent configurations interact with Ignition tag trees to push messages and tag change events to the cloud service. It explains how tags get identified to be pushed as well as what specific 'topics' will be included with the messages. It also goes over some example configurations to show how the system will behave in different scenarios. |
...
| Tip |
|---|
| Refer to the Ignition Tag Browser and Creating Tags documentation for assistance in configuring Ignition tags |
| Anchor | ||||
|---|---|---|---|---|
|
...
Make sure that the Ignition Designer has read/write communications turned on by selecting the Project/Comm Read/Write button highlighted in the image below.
| Tip |
|---|
| Review the Inductive Automation Designer documentation for additional assistance on setting the project communication mode |
...
To refresh the default Tag Agent, open the folder "Azure Injector Control" and click on the Refresh Boolean. When this happens, the Tag Agent will scan the "Edge Nodes" folder and find the new Memory Tags that we have created, construct JSON payloads representing those tags with their current values and publish the payload to the Azure IoT Hub that we have configured.
| Note |
|---|
| The Boolean tag will not change to true. This is really a one-shot and as a result, the tag will not change to true. |
...
