Page History

...

Click Create New Device. The Devices webpage opens.
Make sure that Enabled is "true"
Wait until the Status is "Connected" (This may several seconds, depending on the source and number of tags.)

TIP:   If the status doesn’t change to “Connected,” check the following:

• The controller’s IP address is correct in the module’s configuration.
• The controller is active on the network.
• The controller has tags to report. (If there are no tags in the controller, you can resolve the issue by starting a PAC Control strategy that uses the controller as its control engine.)

Get Tags from the Opto 22 Device

Anchor
GetTags GetTags

...